These European made complete wide tire conversion kits enable you to mount a 200 wide rear tire on a 6.25" wide rim (tire measures8.66") in the stock Dyna frame and still keep the stock 1-1/8" belt drive without trimming. If the wheel is slightly offset, even 230 or 250 can be used. The Kits contains either a raw or black powder coated extra wide swingarm, rear wheel axle, rear wheel adjusters, raw or powder coater fender struts that will take up to a 10-1/2" wide fender, extended upper shock mounting studs, a complete 25mm (0.984") primary offset kit with primary spacer ring, crankshaft extension and crankshaft nut, extended transmission main shaft, extended main drive 5th gear with needle bearings and seal, extended belt pulley spacer, extended clutch pushrod, splash guard, and spacers to offset righthand side foot pegs and the exhaust. Also included are two different brake caliper bracckets to allow the use of either a 1991 thru 1999 or 2000 and later stock or aftermarket rear brake caliper. We offer a wide variety of fender for use with this kit, and can either be found in the fender section of this website, or by contacting us directly.

NOTE~ Tires must be used with manufactures recommended rim size.